Bentley Systems

To Add a Fixed-Point Constraint

The instructions describe how to add a fixed-point constraint to the outer corner of an "L"-shaped profile using the Geometric Constraints toolbox, which reduces the profile's degrees of freedom to four, and then explain that the remaining unfixed vertices, marked with yellow question marks, can be constrained to zero degrees of freedom by adding dimensional constraints either by converting dimensions to constraints or specifying constraints while adding dimensions.

  1. 1.

    In the Geometric Constraints toolbox, select the Fix Point at Location tool.

  2. 2.

    Snap to the profile at the outer corner of the two legs of the "L".

  3. 3.

    Accept to place the fixed point constraint.

    • In the status bar, the message DOF=4 indicates that the profile has 4 degrees of freedom.

With the fixed point constraint in place, and knowing that the profile has 4 degrees of freedom (DOF), you will add dimensional constraints. You will notice that each of the remaining "unfixed" vertices has a yellow marker and question mark (you may need to zoom in to clearly see the yellow question marks). These indicate points that are not fixed. The vertex with the fixed point constraint has a white marker and no question mark.

You will fix the other points, and reduce the degrees of freedom to zero, by adding dimensional constraints to the profile. These can be added in either of two ways:

  • You can dimension the profile and then use the Convert Dimension to Constraint tool to convert the dimensions to constraints.
  • Alternatively, you can specify the constraints as you add the dimensions.

Here are steps that use the latter option.